Cluster with Tacho wiring

[Lukecarter]

Pin 58 on the small ecu plug is the tach signal. Run a cable from there to the tach signal on the back of the cluster.
Then just run a cable from the tacho earth screw to some bare metal behind the cluster.

Alternatively, if you have an MR dash loom installed all you need to do is run 2 short cables from pins 58 and tach earth(will be 57 or 59, can't remember) to the start of the MR loom.

Use the search bar to find the ecu pinout diagram to locate the two pins for tacho signal/earth.

Hi I’ve been following this page and I’m trying to wire mr cluster tako to ce mirage I can see the tako earth but wire do I run the wire from pin 58(where would the tach signal be?