Spoiler Info

IIRC, the boot on a CH is about 40mm wider than the CE so it wont sit flush, so in saying that the existing holes for a CH spoiler wont come close to lining up to a CE wing and you will have to drill some new ones
but that wing in the picture is the same for all series of CE MR, i dont think they changed it at all, so they are very common to pick of ebay for dirt cheap
 
Thanks.

I don't have a spoiler currently so don't have old holes to worry about. Might chase one up and do a test fit to see what it looks like with the gap at the ends.
 
Sorry,
i just looked over a few PM's from way back, it looks like shape and all that is similar, but its infact 70mm wider than the coupe boot (so 35mm short each side), you would probably still pull it off, but it may look a little odd

Look around a few aftermarket shops, im almost certain someone somewhere might have something similar,
check out fibersports, carmate and a few other kit shops to see what they have
 
Like Ces said it wont fit flush cause CH boot is wider than CE, unless you want something like this...

(please excuse the very very badly done photoshop job)
bdpphstsp.png



I suggest looking for a CG spoiler which has the 3 leg thingy you're looking for. Also it's more likely to fit flush than the CE one.
m5CH6OAYH9HPioLR9nCOsIw.jpg
 
Thanks Fella's, will look further into a CG one. All the ones I have looked at for the CG/Ch so far are the two legged ones so will look a bit deeper.
 
You must log in or register to reply here.
Back
Top