Rear sway bar issues

Lancerghini

Lancerghini

Active Member
Hello all,
I bought a 24mm rear sway bar from whiteline and can’t figure out how on earth this is supposed to fit. Am I missing something? It seems wildly too short, and isn’t even long enough to reach any of the mounting points.
IMG_3223.jpeg
Any help is appreciated
 
Oop. If you flip the old one around in your pic - see if the end point line up? Mine has some kinks in it from memory…
 
I spent about an hour under the car trying to figure out how it could fit, but theres no way. Its 100% too short to meet either the swaybar links or the mounting points.

Very womp womp
 
Those bastards lied to me...
this was the one i purchased, I was after the 24mm not the 18mm.
whiteline.com.au

Rear Axle Sway Bar - 24mm 3 Point Adjustable

Benefit Note: Engineered to 'Activate More Grip', sway bars are principally designed to reduce body roll or sway. By reducing body roll, lateral loads are spread more evenly across the tyres thereby increasing cornering grip and improving outright perfor
whiteline.com.au whiteline.com.au

It says its for Mitsu lancer CG, CH, CS but obviously not

Huge womp womp if its actually for the evo X
417524233_2286729488384416_4077024853237044858_n.jpg
 
Unfortunately i don’t think theres an off the shelf 24mm sway bar for the ch, i noticed that on whitelines website they mark parts for the evo 7, 8, 9 and 10 to fit a CG/CH lancer

Its a bit *poo*, but you gotta really look into the finer details of parts to see if they’ll actually fit. The woes of modding a not popular car like the CH lancer
 
You must log in or register to reply here.
Back
Top