Do you wanna be able to warn people that you're braking while doing mad fulleh sikk drifts in your fwd car?
[youtube]https://www.youtube.com/watch?v=QaMUFE7G2Ak#t=24[/youtube]
alright so you'll need
Take out your rear seats and the trim where the seat belts go into. I did mine on the left side but it doesn't matter which side because the brake light wires go along both sides of the boot.
Unwrap the tape that sits under at the ceiling of the boot.
Unwrap the wires and find the green wire. In my car the wire was completely green for the brake light but it might be different in yours, idk.
Cut the wire and strip it then put a test lamp on it and press the break. If it lights up then you're good, if it doesn't then fix the wire up and try another wire.
Wrap your positive wire around a bare part of the green wire and shove it up through the side of the boot and up to where your trim lives.
depending on what light source you use, cut to length and tape it to the back window.
Decide where you want your ground to go.
connect the positive from your light to the positive wire you connected to your brake light wire
Connect the ground then go do some drifts
[youtube]https://www.youtube.com/watch?v=QaMUFE7G2Ak#t=24[/youtube]
alright so you'll need
- Test lamp
Some wire
LEDs or other light source
heat shrink
sticky tape
electrical tape
lighter
and soldering equipment if you're bothered to solder it all.
Take out your rear seats and the trim where the seat belts go into. I did mine on the left side but it doesn't matter which side because the brake light wires go along both sides of the boot.
Unwrap the tape that sits under at the ceiling of the boot.
Unwrap the wires and find the green wire. In my car the wire was completely green for the brake light but it might be different in yours, idk.
Cut the wire and strip it then put a test lamp on it and press the break. If it lights up then you're good, if it doesn't then fix the wire up and try another wire.
Wrap your positive wire around a bare part of the green wire and shove it up through the side of the boot and up to where your trim lives.
depending on what light source you use, cut to length and tape it to the back window.
Decide where you want your ground to go.
connect the positive from your light to the positive wire you connected to your brake light wire
Connect the ground then go do some drifts