googleeyes07
New Member
Took 10 mins of work and $13.89 on eBay.
Simply undo all the screws holding the speedo cover and behind it in, then pull the glass out and then pull the rest out which is holding the spedo and stuff in (Pulling the spedo and rest out needs a bit of force as it is docked into pugs behind it, which means when you pull it out it will disconnect and then when you put it back in later you will have to push it in until it clicks back into the plugs (which is easy peasy) and then getting the spedo and plastic past the steering wheel requires some awkward positioning haha.)
Once the spedo and lot are out turn it around which shows the lights and board which they are all connected to. Locate the ones which light up the spedo, RPM, Fuel, and Temp. Simply twist the globes to unlock them and pull them out and replace with ones you bought (the one on the spedo is a globe to the others as it needs to be wide spread.)
When you put the new globes in make sure the positive and negative are the right way around otherwise they wont work (I did this through trying them all one way and plugging the spedo back in and the ones that didn't work I pulled out and turned around.)
Once all the lights work put it all back together and put it back into the dash and make sure the spedo clicks into the plugs behind by pushing hard and then turning the car lights on to check and make sure they turn on.
Put the spedo cover back on and put all the screws back in and your finished.
Here is the ones I bought: http://www.ebay.com.au/itm/ZPE-Blue-das ... 3f25bc91df
There is one spare globe that comes as you only need 4 for the job,well at least my CC Lancer only needed the 4.
anyone like the looks? Hope this helps some people
They aren't as over brightening as the photo shows haha
They look awesome at night time!
Simply undo all the screws holding the speedo cover and behind it in, then pull the glass out and then pull the rest out which is holding the spedo and stuff in (Pulling the spedo and rest out needs a bit of force as it is docked into pugs behind it, which means when you pull it out it will disconnect and then when you put it back in later you will have to push it in until it clicks back into the plugs (which is easy peasy) and then getting the spedo and plastic past the steering wheel requires some awkward positioning haha.)
Once the spedo and lot are out turn it around which shows the lights and board which they are all connected to. Locate the ones which light up the spedo, RPM, Fuel, and Temp. Simply twist the globes to unlock them and pull them out and replace with ones you bought (the one on the spedo is a globe to the others as it needs to be wide spread.)
When you put the new globes in make sure the positive and negative are the right way around otherwise they wont work (I did this through trying them all one way and plugging the spedo back in and the ones that didn't work I pulled out and turned around.)
Once all the lights work put it all back together and put it back into the dash and make sure the spedo clicks into the plugs behind by pushing hard and then turning the car lights on to check and make sure they turn on.
Put the spedo cover back on and put all the screws back in and your finished.
Here is the ones I bought: http://www.ebay.com.au/itm/ZPE-Blue-das ... 3f25bc91df
There is one spare globe that comes as you only need 4 for the job,well at least my CC Lancer only needed the 4.
anyone like the looks? Hope this helps some people
They aren't as over brightening as the photo shows haha
They look awesome at night time!