ok. i did it about 2 weeks agoe.
for aircon cluster:
1. pull of the aircon knobs, there should be screws underneath
2. undo those screws and keep track of what ones they are.
3. put your hand through the gap in the top of the glove box to that pane of trim and push, be farely forceful because its only held on be clips and should just push out.
3. underneath is a sort of plastic thing that has the buttons on it, there are i think 2 screws on it?? its fairly obvious so unscrew those and take off the plastic thing
4. then there is a clear plasic bit where you unscrew it (screws i think are in the corner of that white bit) and take that off.
5. now you have access to the LEDs. you can either take them out and switch them or do what i did and get one of those rubber condoms from autopro that changers the colour.
6. put everything back together and enjoy
cig lighter:
1.first unscrew the rear centre console bit (the bit with cupholders) then pull upwards from where that trim part meets with the part next to the gear stick.
2. there should be 2 screws now just near where the trim part we took off was clipped, on the base of the next one, next o the wiring loom. undo those and as for al screws, keep track of what is which.
3. theres a plastic push in screw on the drivers footwell. push the middle bit in with a screwdriver and then it should be easily able to be pulled out.
4. this is hard to describe this part... uhhh... in the passenger footwell, (this is from if you were facing it from standing at the passenger door)
there is this seperate peice of plastic that you have to pull out on the faaar left of this centre trim. feel ffree to pull it farely hard as it only is held by clips.
5. once that is off there are some screw things similar to the one of the drivers side footwell.
7. now pull out the ashtray and undo that screw underneath.
6. if you want to, you can take off your gear knob, but you dont have to, just makes it a bit more difficult.
7. ok now pull off your trim over your gearstick if you took the knob off or just angle it upwards (i leant it on the handbrake and it helps to unplug the loom next to the screws in step 2
you shoul have access to the plugs under the cig lighter now.
8. find out which plug is the led (it twists out rather than pulls)
9. you can now either replace the led on it or use a condom like i did
10. the ashtray light is easy to do as it is he only plug there.
11. put everything back together in reverse of how you took it apart and youre set
enjoy