guys, i am wanting to make up a cold air intake unit for my ce and know i can get the first 90 degree silicon bend from throttle body to maf sensor then after this sensor i want to run a pipe straight ahead abit and then down towards the radiator bottom to where the filter with housing will be attached. i am not fussed with going through the side front guard as i feel in wet weather the swirling of excess water will play havoc with the filter, this is why i want to keep the filter low under bonnet just below the radiator bottom if that . now is there a pipe available or do i have to have one bent to suit ? thanks.
CAI for my CE Coupe
- Thread starter lancermr
- Start date
- Status
1. you need to use some damn punctuation
2. make your question clear
3. search.
4. search again, its a peice of pipe.
close thread.
edit:
you're lucky i like MSPaint so much
ingredients:
2x long leg 90'bends
peice of pipe cut to lenght from exhaust shop
few hose clamps
some scrap to make a bracket
2. make your question clear
3. search.
4. search again, its a peice of pipe.
close thread.
edit:
you're lucky i like MSPaint so much
ingredients:
2x long leg 90'bends
peice of pipe cut to lenght from exhaust shop
few hose clamps
some scrap to make a bracket
:evil: USE SEARCH FUNCTION!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! :evil:
this question and many many more about doing CAI's etc is VERY well documented and covered in thread linked below and this same question has been answered countless times
viewtopic.php?f=8&t=769
this question and many many more about doing CAI's etc is VERY well documented and covered in thread linked below and this same question has been answered countless times
viewtopic.php?f=8&t=769
electronix
New Member
Res have you check your PMs mate?
/thread hijack
/thread hijack
- Status