LaNcE
Member
Further to this I may be selling my pair as I will be going in a different direction and would need to buy series 1 headlights instead.
I might have a pair of CE 1 angel eyes if you want to swap em with the fogs? =P
Further to this I may be selling my pair as I will be going in a different direction and would need to buy series 1 headlights instead.
Bahahaha noI might have a pair of CE 1 angel eyes if you want to swap em with the fogs? =P
You could, I'd look in to costs first and see if its worth it.
The advantage of having OEM lights is that, the brackets all fit and screw in to thier proper spots and it plugs in via the factory wiring. On that note probably an idea to check that the factory foglight wiring is there, usually tied up either side of your radiator just down from your parker light wiring. Id so, all you'd need it a light switch for your dash and youre good to go.
Cheers!
I was just wondering whether there might be a missing relay that needs to be plugged in, as per power windows/mirrors install.
Yeah that I know, did it on the weekend.For the windows yes, you need the relay.
Yeah that I know, did it on the weekend.
Was wondering whether there was a sneaky relay required somewhere to get fog lights working.
There not real sneaking or rocket science in it. If you’ve got MR interior and front looms, it’s all plug n play.
If your still running a stock interior loom, it won’t have the additional wiring from the on off switch to the connector plug where the two looms meet.
I did have a picture somewhere which showed my original Mirage loom and the MR front loom and the missing white wire.
I’ll see if I can find it on another post.
Ok interestingYou maybe good to go, only one way to find out.
Otherwise, check the wiring as below.
Ok so I’m now a bit confused - the ‘missing’ white wire isn’t on the side that runs up to the switch - it’s the side that then vanishes into the main loom.The plug was behind the dash for the switch, but missing the wire.
No plugs behind the bumper for the lights themselves.
Ok so I’m now a bit confused - the ‘missing’ white wire isn’t on the side that runs up to the switch - it’s the side that then vanishes into the main loom.
So if this wire is missing, where do I need to patch into to restore that connection?
Exactly, but I didn’t bother.
I had just swapped out my entire interior loom rather that wire it.
I hate wiring wires, saved myself the drama of following wires everywhere and just swapped it all over so it was like it rolled out of the factory.