Engine conversion 1.8l to 2.0l

Cool I will do all that over the next month. I'm hoping to get it on the road within 2 months. Just concerned about the tyres not passing roadworthy. One side seems slightly lower than the other
 
Does the drivers side seem a bit higher? That would be to compensate for the driver when they're in the car. Would level it out more. If not that then check all the tyre sizes are the same. If there's a noticeable difference it could be a mismatched shock/spring combo on one side
 
rigby said:
Give it a basic service, replace all fluids and filters and plugs etc. Clean the MAF sensor if it has one (idk g94 life) and the throttle body. That will eliminate a lot of possible problems and narrow down any issue if there still is one.
Click to expand...
You can see the maf in the photo hahahah
 
rigby said:
Does the drivers side seem a bit higher? That would be to compensate for the driver when they're in the car. Would level it out more. If not that then check all the tyre sizes are the same. If there's a noticeable difference it could be a mismatched shock/spring combo on one side
Click to expand...
Yeah all tyres are the same and it lower on drivers side
About 3/4 of an inch lower
 
Could just be the guard itself from the lip has been pulled down. On second look it's just the drivers side front. I could just roll it back
 
You must log in or register to reply here.
Back
Top