Sedan rear window visor fitment to coupe

garnget

Member
Lifetime Premium Member
Ok. So I've seen a few posts with people asking about fitting the sedan visor to the coupe and been told it sort of fits, well just did it and it's not perfect but it does fit and hey I'll live with it.
So yeah first up when you put it on, use some duct tape to hold it in place and you'll notice that a the visor is tight to the roof line in the centre but drops down 8-10mm at either outside edge of the screen. Further pics will show this better, but you'll also notice that when put into the window rubber tight on one side it is tight at the bottom but gappy at the top as above pics shows.
aTsHfrQm.jpg

Second pic shows the drop down either side and also how much it overhangs the window rubber on the left side of the screen when the right is tight to the rubber.
PE2L001m.jpg

So essentially what you have to do is put some masking tape over either side of the left and right edges then use a cutting implement ( i used my cordles plane taking off about 1mm at a time) and taper a cut on either edge of about 6mm on the bottom edge of the visor up to3mm at the top of the visor. You'll also probably need to put new double sided tape on both sections as the cutting will probably stuff it.
You should end up with something like below.
bRO734Im.jpg

You could also scribe the top section so it follows the roof line better. But I wasn't that keen :)
g4Nvacxm.jpg
 
Last edited:
Back
Top