Importing head lights and tail lights from the states..

NICE AS

NICE AS

New Member
Okay just want to double check some stuff and confirm

Will all these fit a ce coupe???????


Tail ligths

http://cgi.ebay.com/ebaymotors/1997-199 ... ccessories

I like these
http://cgi.ebay.com/ebaymotors/99-02-MI ... ccessories

http://cgi.ebay.com/ebaymotors/Mitsubis ... ccessories



Head light some are 1 peice some are 2.

What would I have to change for 1 peice front bar??

http://cgi.ebay.com/ebaymotors/97-98-99 ... ccessories

http://cgi.ebay.com/ebaymotors/02-03-MI ... ccessories

Like these

http://cgi.ebay.com/ebaymotors/2002-200 ... ccessories

http://cgi.ebay.com/ebaymotors/2002-200 ... ccessories

Will the all bolt on???????
 
those head lights wont fit, they are the next modle lancer
 
Wont fit, theyre for 4 door. Youd have to do the same conversion James did. I like those all red LED rear lights you have in there, but they look like theyve got the kink in them, and your bootlids one of the older CE bootlids isnt it? Youd prob have to get a newer bootlid for them to sit flush
 
Yer but I dont wanna pay 500 for them lol.

Like those lights led ones there $300 and up some $400 way to expensive
 
You'd also need to make sure there is enough adjustment in them to correct them from LHD setup to RHD setup, otherwise they'll be throwing a beam right into oncoming cars...
 
Yeah they should fit, i like that front bar on the red one in the pic too! From memory, I dont think the older lancers had the different LHD - RHD light disbursement. By that I mean I think they came out equal the whole way across and didnt have the step where the left hand side's beam lights up further than the right hand side. So if thats the case, you prob wont have to worry bout LHD vs RHD in this. Some1 mite be able to confirm though?
 
Mounts are slightly different I think. I didnt realise you had the two piece ones, should keep them and get the amber indicators
 
Have you thought about blacking out your headlights (open them up and paint the inner part) and amber corners? The cap that covers the actual bulb has a cutout more to one side to stop the blinding of oncoming traffic for the Aussie headlights, I am not entirely sure if the projector lenses have this or if it even matters with them. I think you can cut out the centre part and fit one piece headlights, you'd just have to compare your car to someone with one pieces.
 
opening up ur headlights isnt hard. i recomend trying this with ur stock headlights, itll save u $$$. just be careful when u do it as to not snap anyhting.

p.s i like the black tail lights with lots of little red LED's. i want them oneday maybe!!!
 
You must log in or register to reply here.
Back
Top