th0m0mx83
Active Member
Soooo Here is how you do it.
Remove door car from door
Remove old crap from said door (before moving on clean any dust left behind with prepsol or something. i also went over it quickly with sand paper doubt it helped)
Use your old material as a rough template, Cut a good 1-1.5in atleast around it. This sht will need stretching.
Next Spray the glue on both surfaces(or follow can directions if its different) and start placing the material down. (probably better to start at the top but up to you)
Now once thats done Grab something that will fit in the ridge in the plastic and slowly run it around.
Now you can trim the material. either lift it up slowly and cut as you go (i did. was a pain with scissors) Till your left with this
Remove door car from door
Remove old crap from said door (before moving on clean any dust left behind with prepsol or something. i also went over it quickly with sand paper doubt it helped)
Use your old material as a rough template, Cut a good 1-1.5in atleast around it. This sht will need stretching.
Next Spray the glue on both surfaces(or follow can directions if its different) and start placing the material down. (probably better to start at the top but up to you)
Now once thats done Grab something that will fit in the ridge in the plastic and slowly run it around.
Now you can trim the material. either lift it up slowly and cut as you go (i did. was a pain with scissors) Till your left with this