DR1FT
New Member
did this on impulse one day, looks mint
1. you will need to either trim or file the hole where your cable is going into it. i did this with a very fine file.
once you have done that it should have a tight fit.
2. now either file or cut the excess bulky bits of the side what will be hidden underneath.
3. line up where you want to put the holder and mark it out. then get an 8.5 drill bit and drill along the line. its a little bit thinner then the holder so i used a file for that extra mm gap.
4. make sure it fits with a really tight fit. then use the nessesery glue, i used silicon glue since it was the only thing around lol.
now that its complete it should look somthing like this.
]
1. you will need to either trim or file the hole where your cable is going into it. i did this with a very fine file.
once you have done that it should have a tight fit.
2. now either file or cut the excess bulky bits of the side what will be hidden underneath.
3. line up where you want to put the holder and mark it out. then get an 8.5 drill bit and drill along the line. its a little bit thinner then the holder so i used a file for that extra mm gap.
4. make sure it fits with a really tight fit. then use the nessesery glue, i used silicon glue since it was the only thing around lol.
now that its complete it should look somthing like this.
]