Hey guys, just repaired my 2003 CG, involved a new control arm and tie rod end for the front left of the car. Everythimg seemed fine until I started the car up and noticed only the front right wheel (the one that wasn't damaged) spins when in gear, the left wheel doesn't spin at all. What could be the problem?
2003 CG-Replaced control arm, still something wrong?!
- Thread starter Jfawk94
- Start date
- Status
Thank Thomo for your wise words. Unfortunately I am clearly not as much as a lancer expert as you are, I hope this knowledge serves you well throughout the rest of your life.
I was aware that the car was on stands as I was the one who put it there. I wanted to make sure the car was fine before I put it down again to save the trouble of finding a problem and having to jack it back up again to fix something that could have been prevented from happening in the first place, hence the question.
Nonetheless, thank you for your input, and I apologise for any inconvenience my lack of knowledge may have caused you.
I was aware that the car was on stands as I was the one who put it there. I wanted to make sure the car was fine before I put it down again to save the trouble of finding a problem and having to jack it back up again to fix something that could have been prevented from happening in the first place, hence the question.
Nonetheless, thank you for your input, and I apologise for any inconvenience my lack of knowledge may have caused you.
- Status