HELP INSTALLING A B eer rev limiter

2FAST4U

New Member
I have a bee r rev limiter and I have already wired it up to a switch but I’m having troubles with the ecu part as I don’t know where it is, I have looked in the pass footwell and there is only 3 plugs, I’m wondering if someone has wired one to a 2.4l limited edition CH lancer. That can help me out.
 
Your tachometer wire is on the left side of the engine bay. I circled it in the photo below. You can run the wire into the engine bay to connect to it. Or you can trace it to ECU but i don't know what wire colour it is.
 

Attachments

  • 20210127_163655.jpg
    20210127_163655.jpg
    1.7 MB · Views: 18
Last edited:
Give me about more information on which ignition wire you need. When you say ignition wire, do you mean the wire from ECU to the coil? Or you mean the ignition wire in ignition key switch or something else?
 
Give me about more information on which ignition wire you need. When you say ignition wire, do you mean the wire from ECU to the coil? Or you mean the ignition wire in ignition key switch or something else?
yes the wire from the ecu to the coils
 
yes the wire from the ecu to the coils
In the engine compartment, you can unplug the first spark plug connector and look at the wire colours. There are 3 wires (black, white and another colour). That other colour is the ECU wire to the coil. You can trace it to ECU connector in the cabin. Each coil will have it's own wire colour apart from black and white.
 
Give me about more information on which ignition wire you need. When you say ignition wire, do you mean the wire from ECU to the coil? Or you mean the ignition wire in ignition key switch or something else?
I’m looking for the ignition wire to cut out when I reach the desired rpm.. would you help me with this please.
 
Back
Top