Offering this to local members or members that can leave their car in Sydney for a custom exhaust system.
I can say with confident that you will struggle to find a better exhaust installation.
I'm sick and tired of see crap piping jobs, cut corners, overpriced, people paying too much and getting poor quality custom work.
I only do mandrel bent systems for flow. Mild steel to keep cost down. Can arrange custom stainless tig welded mandrel system at significantly more cost.
Size can range from 2inch right through to 3.5/4 inch.
If anyone cares to meet up with me I can show you the work quality on my own car.
All worn rubber hangers are replaced with solid hangers to reduce movement. Nothing worse than a wobbling exhaust when driving.
I dont reuse undersized stock flanges and cause unnecessary restrictions because I dont have the same flange in stock.
I carry the factory bolt spacing flanges and can design the system to be bolt on to stock cat convertors etc.
Hi mate, I'm in Newcastle and it would be a good opportunity to come down on one of my next days off... I would like a system that gives more power but I don't want to draw attention too much.. I'd just let you give me advice and I would go with that. When would be a good time to come down?? I have tomorrow off work and could come down if you could fit me in by any chance.... looking forward to catching up...Offering this to local members or members that can leave their car in Sydney for a custom exhaust system.
I can say with confident that you will struggle to find a better exhaust installation.
I'm sick and tired of see crap piping jobs, cut corners, overpriced, people paying too much and getting poor quality custom work.
I only do mandrel bent systems for flow. Mild steel to keep cost down. Can arrange custom stainless tig welded mandrel system at significantly more cost.
Size can range from 2inch right through to 3.5/4 inch.
If anyone cares to meet up with me I can show you the work quality on my own car.
All worn rubber hangers are replaced with solid hangers to reduce movement. Nothing worse than a wobbling exhaust when driving.
I dont reuse undersized stock flanges and cause unnecessary restrictions because I dont have the same flange in stock.
I carry the factory bolt spacing flanges and can design the system to be bolt on to stock cat convertors etc.
Hi mate, are you free tomorrow at any stage.. I'd like a system put together by you. Where in Sydney are you located??
Thanks mate, will do... I didn't think my phone was working properly this morning, hence why I msged a few timesChill. Hens isn't on here very often. Try message him on facebook (HENSPerformance).
Thanks mate, will do... I didn't think my phone was working properly this morning, hence why I msged a few times