4g15 Mirage, I can't find Rpm signal and ignition signal wires Bee*R limiter help

Chace

Chace

New Member
Hey guys, was really hoping someone here could please steer me in the right direction to what I'm missing here..
Long story short after many hours trying to find these wires and install my bee*R limiter and failing to find these wires I've almost given up..
Does anybody know if I can wire a Bee*R by only splicing into the ecu, if so does anybody happen to have a ecu pinout diagram and if not does anybody know where to find these wires? I have a aftermarket cluster with a tachometer that's wired up if that helps too.
Is there any tips or advice or even anybody who's installed a bee*R on a 4g15?
Thanks in advance :)​
 
The bee r limiter comes with exact diagram of the pinout for you.
It shows you exactly what wires to use
 
I don't see any here for me go off pinouts wise, not any for my engine anyway. If it showed me exactly what wires to use I wouldn't be in this situation :/
The only one that looks similar would be m02 diagram for the 4g92..
Only difference between the two is mine doesn't have a crank angle sensor wire going into the ecu (I think) if there is does anyone know what number or what wire to tap into instead?
 

Attachments

  • Screenshot_2015-08-30-15-32-14.png
    Screenshot_2015-08-30-15-32-14.png
    688.7 KB · Views: 26
if the diagram isnt on the paper they send you then it wont work.

tried to hook it up to a euro car, wouldnt have a bar of it.
 
You must log in or register to reply here.
Back
Top